Micromod MOD: 30ML Operation and Template Setup Uživatelský manuál stáhnout pdf (Strana 21)

MOD 30ML Operation

SETUP

2-11

Table 6. Template Configuration (Cont’d)

Step Step Description Line 1 Line 2 Line 6 Entry Description

6C Install Template

∇ move down to 6C1

NXT, PRV change step

INSTALL TEMPLATE

Installation verifies and loads the

template making it the active

database (changes state to RUN).

6C1 Installation of Template

∇ ∆ select YES (press again from

NONE returns you to Step 6C)

ENT loads template and displays

first runtime display.

INSTALL TYPE NONE

Select NONE to exit installation.

Select INITCOLD to install and

RUN template using a cold start.

Select INITWARM to install and

RUN template using a warm start.

6C2 Configuration Request Failed

ACK acknowledges failure

message and changes to Step 6B.

CONFIG REQUEST FAILED

Data base verification failed

because of some inconsistency in

database or an active shutdown

condition. To ACK failure, go to

DEV STAT level and set ACK SD

to Yes (Step 1B5).

6D Template (Exit)

∆ moves up to Step 6

NXT, PRV change step

TEMPLATE

Table 7. System Template Configuration

Step Step Description Line 1 Line 2 Line 6 Entry Description

7A System Device Tag

∇ ∆ change a character

NXT, PRV flash to change position

ENT enters new device tag.

NXT, PRV change step

SYSTEM DEV TAG TEMP 100

Modify device tag using standard

set of characters. This tag identifies

instrument.

7B System Scan Groups (Entry)

∇ moves down to Step 7B1

NXT, PRV change step

SYSTEM SCANGRPS

Scan groups 1 through 5 are user

defined intervals for loops. The

fastest group has the highest

priority. The lower numbered group

has a higher priority if the interval is

the same.

7B1 Scan Group 1 Interval