Micromod MOD: 30ML Operation and Template Setup Uživatelský manuál stáhnout pdf (Strana 75)

MOD 30ML Operation

APPENDIX A - EVENT CODES

A-13

Table A-2. Event Codes, Description and Action

Block

Type

Codes Full Message Text Description/Action

PID 0 BLOCK STATE SET TO RUN Information only.

PID 1 BLOCK STATE SET TO HOLD Information only.

PID 2 BLOCK STATE SET TO OFF Information only.

PID 3 BLOCK STATE SET TO DEBUG Information only.

PID 4 CALCULATION ERROR A calculation error (calculation overflow, divide

by zero, etc.) has been detected in calculations

which do not affect the control output (e.g.,

adjusted set-point calculation). The block

completes the calculation using some

reasonable value (+ or - maximum value for

overflows, etc.), and sets the output qualities

according to the configuration of Attribute No.

58, Calculation Error Action (CERRACT). The

diagnostic error clears and the quality is set

back to good when a subsequent execution of

the block performs a successful calculation.

PID 5 CONTROL OUTPUT CALCULATION

ERROR

A calculation error (calculation overflow, divide

by zero, etc.) has been detected while

calculating the control output value. The block

completes the calculation using some

reasonable value (+ or - maximum value for

overflows, etc.), and sets the output qualities

according to the configuration of Attribute No.

58, Calculation Error Action (CERRACT).. The

diagnostic error clears and the quality is set

back to good when a subsequent execution of

the block performs a successful calculation.

RDIM 4 CHANNEL 0 MODE SET TO AUTO Information only.

RDIM 5 CHANNEL 0 MODE SET TO MANUAL Information only.

RDIM 6 ••• Repeat for Channels 1 to 14

RDIM 34 CHANNEL 15 MODE SET TO AUTO Information only.

RDIM 35 CHANNEL 15 MODE SET TO MANUAL Information only.

RDIM 36 I/O MISMATCH A configured address on the CS-31 bus is not

used or the installed remote module does not

match the address configuration.

RDIM 37 MODULE EXTENDED ERROR A remote module has reported an error.

Codes identifying reported error are stored in

the block database as extended errors. The

error codes can be viewed via Attribute Nos. 31

- 46, Extended Error (EXTERR).

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 83 84

Komentáře k této Příručce

Žádné komentáře

Micromod MOD: 30ML Operation and Template Setup Uživatelský manuál Strana 75

Komentáře k této Příručce

Související produkty a manuály pro Zařízení Micromod MOD: 30ML Operation and Template Setup