Micromod MOD: 30ML Operation and Template Setup Uživatelský manuál stáhnout pdf (Strana 66)

MOD 30ML Operation

APPENDIX A - EVENT CODES

A-4

Table A-2. Event Codes, Description and Action (Cont’d)

Block

Type

Codes Full Message Text Description/Action

EX 0 BLOCK STATE SET TO RUN Information only.

EX 1 BLOCK STATE SET TO HOLD Information only.

EX 2 BLOCK STATE SET TO OFF Information only.

EX 3 BLOCK STATE SET TO DEBUG Information only.

EX 4 CALCULATION ERROR One of the following conditions was detected:

• There is a calculation error (calculation

overflow, divide by zero, square root of

negative number etc.). The block completes

the calculation using some reasonable value

(+ or - maximum value for overflows, zero for

square root of negative number, etc.), and

sets the output quality bad if Attribute No. 10,

Set quality bad on calculation error?

(SETQBAD) is YES. The diagnostic error

clears and the quality is set back to good

when a subsequent execution of the block

performs a successful calculation.

• Improper syntax in the expression.

• A stack overflow due to too many nested

operations.

IC 0 BLOCK STATE SET TO RUN Information only.

IC 1 BLOCK STATE SET TO HOLD Information only.

IC 2 BLOCK STATE SET TO OFF Information only.

IC 3 BLOCK STATE SET TO DEBUG Information only.

IC 4 RECEIVING UNEXPECTED MESSAGE There is a configuration error (source or data

type incorrect) within either this block or within

an Output Communication block in another

instrument.

IC 5 NOT RECEIVING DATA A break in the communications has halted the

continual flow of data from the source. No new

data has been received for 2 seconds.

IC 6 BLOCK MODE SET TO MANUAL Information only.

IC 7 BLOCK MODE SET TO AUTO Information only.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 83 84

Žádné komentáře

Micromod MOD: 30ML Operation and Template Setup Uživatelský manuál Strana 66