Micromod MOD: 30ML Operation and Template Setup Uživatelský manuál stáhnout pdf (Strana 81)

MOD 30ML Operation

APPENDIX A - EVENT CODES

A-19

Table A-2. Event Codes, Description and Action

Block

Type

Codes Full Message Text Description/Action

TOT 0 BLOCK STATE SET TO RUN Information only.

TOT 1 BLOCK STATE SET TO HOLD Information only.

TOT 2 BLOCK STATE SET TO OFF Information only.

TOT 3 BLOCK STATE SET TO DEBUG Information only.

TM 0 BLOCK STATE SET TO RUN Information only.

TM 1 BLOCK STATE SET TO HOLD Information only.

TM 2 BLOCK STATE SET TO OFF Information only.

TM 3 BLOCK STATE SET TO DEBUG Information only.

VCI 0 BLOCK STATE SET TO RUN Information only.

VCI 1 BLOCK STATE SET TO HOLD Information only.

VCI 2 BLOCK STATE SET TO OFF Information only.

VCI 3 BLOCK STATE SET TO DEBUG Information only.

VCI 4 CALCULATION ERROR A calculation error (calculation overflow or

divide by zero) has been detected. The block

completes the calculation using some

reasonable value (+ or - maximum value for

overflows and divide by zero), and sets the

output quality bad if Attribute No. 10, Set quality

bad on calculation error? (SETQBAD) is YES.

The diagnostic error clears and the quality is

set back to good when a subsequent execution

of the block performs a successful calculation.

VCIM 4 BLOCK MODE SET TO AUTO Information only.

VCIM 5 BLOCK MODE SET TO MANUAL Information only.

VCIM 6 I/O MISMATCH A configured slot is either empty or the installed

module does not match the slot configuration.

VCIM 7 I/O COMMUNICATIONS ERROR One of the following conditions was detected:

• There is a checksum error in the

communications between this block and the

module.

• The select circuit, which is used to

communicate with the module, has a

diagnostic error. In this case, all modules

report a communications error.

VCIM 8 VI MODULE ERROR The module has reported an error which is

identified by an extended error code. The

error codes can be viewed via Attribute No.18,

Extended Error (EXTERR).

1 2 ... 76 77 78 79 80 81 82 83 84

Komentáře k této Příručce

Žádné komentáře

Micromod MOD: 30ML Operation and Template Setup Uživatelský manuál Strana 81

Komentáře k této Příručce

Související produkty a manuály pro Zařízení Micromod MOD: 30ML Operation and Template Setup