Micromod MOD: 30ML Operation and Template Setup Uživatelský manuál stáhnout pdf (Strana 60)

MOD 30ML Multiloop Controller

OPERATION

3-28

5. Tune the configured control parameters using the front panel keys as shown in the

illustration. The parameters available for tuning are as follows:

• Parameters which are always available:

Action [ACTION], Gain [GAIN], Reset [RESET], Preact [PREACT], Set-Point Low

Limit [SP LOLIM], set-point high limit [SP HILIM], output low limit [OP LOLIM],

output high limit [OP HILIM].

• Parameters which are available only when configured:

Filter type [FIL TYP], Filter Time [FIL TIME], Feed Forward Gain [FF GAIN], Feed

Forward Bias [FF BIAS], and Manual Reset [MAN RSET]. Prior to the

appearance of the feed forward gain and bias parameters, the Feed Forward

Type [FF TYPE] is identified on Line 6 as [MULT] or [ADD] for information only; it

is not tunable.

6. When the [EXIT] [TUNING] prompt appears after the last tuning display, proceed as

follows:

• Press the R/L[PRV] key to return to the previous display.

• Press the Scroll[NXT] key to return to the start of the tuning sequence.

• Press the Up [∆] key to return to the runtime displays.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 83 84

Žádné komentáře

Micromod MOD: 30ML Operation and Template Setup Uživatelský manuál Strana 60